The (new) Crosman Forum, your first and last stop for all things Crosman


120_2001r.jpg

Scot Laughlin's Custom All Weather 2260

2260 with short crosman receiver atop a mini riser made from aluminum tube. Barrel is a 2200 soda straw
tensioned inside a titanium golf club shaft. Three screw mod to the trigger, bulk co2, SSP 250 rear cocking
striker assembly. Factory stock, reshaped, bedliner finish and stick on cheek piece. The idea was a weather
resistant light hunter for rainy days.
I've got a Cothran stainless receiver and gas tube waiting for me to get back to this one.

 Return to Index  

Is it an actual barrel or a liner...

February 16 2012 at 10:00 PM
Phil  (Login Duane30)
Crosman Forum Member
from IP address 74.140.196.166


Response to How do I fix a bent barrel.

Liners often are very much subject to getting bent/warped - in particular the very thin walled liners. The reason is that they are meant to installed in a thick walled bored out barrel, which will align them straight.

What you can do, if this barrel is for a Crosman breech project, is get a steel tube that is straight, same I.D. as that of the O.D. of the barrel, and use it up to the breech, butt it against the breech.

"The majority of things in our lives are created by folks no smarter than the rest. Afterall, the world is comprised, and operated by C average people intellctually, academically, and morally. These people are often the great pioneers that set the precedent for what excellence should be."

 
 Respond to this message   
Responses

Crosman Corporation 1-800-724-7486

This forum is not affiliated with the Crosman Corporation in any way// Information presented in this forum is intended for informational purposes only; use at your own risk//Posts made to this forum are solely the opinion of the individual member