The (new) Crosman Forum, your first and last stop for all things Crosman

 photo 63f5b325-0274-4312-9dbd-2effde5b3715_zps0x27orls.jpg

Alan Alford's build

2250b Tube for later move to bulk CO2.
12" .22 Caliber Barrel from Doomsday Backpacker
Brian & Assoc. Alluminum Breech with 2 barrel screws
Original site rear
Pin site on Custom Mt. Airguns Muzzle Break
2x1 Centerpoint Scope with UTG dovetail adapters
Mountain Airguns Custom Bolt and Handle
Mountain Airguns Custom Power Adapter and spring guide
B&A Boss Valve for extra Power

Built mainly for fun and to shoot at local Field Trial Pistol Match.

It currently it shoots a 14.3 Crosman Hunting Pellet at about 530 fps in a 72 degree room for 8.92 FPE.



 Return to Index  

Is it an actual barrel or a liner...

February 16 2012 at 10:00 PM
Phil  (Login Duane30)
Crosman Forum Member
from IP address 74.140.196.166


Response to How do I fix a bent barrel.

Liners often are very much subject to getting bent/warped - in particular the very thin walled liners. The reason is that they are meant to installed in a thick walled bored out barrel, which will align them straight.

What you can do, if this barrel is for a Crosman breech project, is get a steel tube that is straight, same I.D. as that of the O.D. of the barrel, and use it up to the breech, butt it against the breech.

"The majority of things in our lives are created by folks no smarter than the rest. Afterall, the world is comprised, and operated by C average people intellctually, academically, and morally. These people are often the great pioneers that set the precedent for what excellence should be."

 
 Respond to this message   
Responses

Crosman Corporation 1-800-724-7486
This forum is not affiliated with the Crosman Corporation in any way// Information presented in this forum is intended for informational purposes only; use at your own risk//Posts made to this forum are soley the opinion of the individual member