logo by smgunner
Return to Index
Thanks again Sean.
February 21 2012 at 10:04 PM
Crosman Forum Member
from IP address 22.214.171.124
I sent you........
This is above and beyond. Another question. If I cut say a 1/4 inch off the contact side of the hammer. Will that give the hammer more momentum when it hits the valve stem to push it open more?
Respond to this message
I did not think through the hammer statment.
- Mike on Feb 22, 2012, 6:49 AM
Trim the valve stem
- Sean in VA-VB on Feb 22, 2012, 10:30 AM
OK now I feel like a goober. Much easier thanks.
- Mike on Feb 22, 2012, 9:52 PM
Crosman Corporation 1-800-724-7486