Carl Quick's LiteWieght 2240
So for about the last 24 months, I've had her on a serious diet. Now I am happy to
report that she lost nearly 13 ounces and is feeling so much better. And let me
say one thing, when I pick her up with one hand now she is light as a feather.
Well, almost a feather.
Things I have done so far:
OEM main tube was lightened by me.
Barrel is OEM and trimmed down by me.
Main tube plug is made of Delrin by me.
Gas cap is aluminum, comes from HPA and bored out by me.
Hammer is made from Delrin by me with a modified 1701P striker.
Valve is an aluminum Disco rear end with a brass Pro-Top by Anthony.
Trigger grip frame is aluminum by Bluefork Design and then hogged out by Gregg.
Front barrel band is aluminum, made by Anthony, drilled by Rich and milled by me.
Yep, the tube and barrel bending, the rubber piston cup being compressed,March 12 2012 at 6:12 AM
|james perotti (Login jpsaxnc)|
Crosman Forum Member
from IP address 22.214.171.124
Response to By design, the Benji gunframe is already a spring
and the pump linkage being compressed. There might be 3/16" worth of expansion after the trigger is pulled.
|This message has been edited by jpsaxnc from IP address 126.96.36.199 on Mar 12, 2012 6:16 AM|
Crosman Corporation 1-800-724-7486
This forum is not affiliated with the Crosman Corporation in any way// Information presented in this forum is intended for informational purposes only; use at your own risk//Posts made to this forum are solely the opinion of the individual member