The (new) Crosman Forum, your first and last stop for all things Crosman


Jim Gillilan's Custom 1322 Carbine

Jim Gillilan's Custom 1322 Carbine w/Custom Stock

Here's one I'm especially proud of and is modded all over, doing 12fpe at 15 pumps.
Stock is Teak from Thailand and super light weight 1322 Carbine!

 Return to Index  

180 with QB78 stock cut to fit

April 5 2012 at 1:28 PM

andy  (Login FortWarren)
Crosman Forum Member
from IP address 24.218.244.126

I have a 180 that has an original stock thats a little beat up. I wanted a nicer stock but wanted to leave the original alone so last week I cut down a QB78 stock to fit. Left a little more meat than the original stock, and with the butt pad and little longer forearm it added around 2 3/4 crucial inches for a more 'adult' feel. You can see it in the 2nd pic that I had to drill a new hole for the locating stud and the old hole is a bit unsightly but I'm not a perfectionist so it doesn't bother me. White butt spacer did not come out as clean as I hoped but again, Im satisfied with it. It was one of the old orange painted, gross looking QB stocks that someone gave me last year because they were gonna just throw it away. wood grain is decent I would say.
One things I really like about this gun is it shoots the 22 gamo round balls just as accurate as can be at high and low power. It really is a hole on hole gun, I just cant get enough of it. Also it has the all brass valve.
Anyway hope you like it too!

Before and after pics

CR180

Photobucket

Photobucket

 
 Respond to this message   
Responses

Crosman Corporation 1-800-724-7486

This forum is not affiliated with the Crosman Corporation in any way// Information presented in this forum is intended for informational purposes only; use at your own risk//Posts made to this forum are solely the opinion of the individual member