The (new) Crosman Forum, your first and last stop for all things Crosman

CG01.jpg CG01.jpg

Carl Quick's LiteWieght 2240

So for about the last 24 months, I've had her on a serious diet. Now I am happy to report that she lost nearly 13 ounces and is feeling so much better. And let me say one thing, when I pick her up with one hand now she is light as a feather. Well, almost a feather.

Things I have done so far:

OEM main tube was lightened by me.
Barrel is OEM and trimmed down by me.
Main tube plug is made of Delrin by me.
Gas cap is aluminum, comes from HPA and bored out by me.
Hammer is made from Delrin by me with a modified 1701P striker.
Valve is an aluminum Disco rear end with a brass Pro-Top by Anthony.
Trigger grip frame is aluminum by Bluefork Design and then hogged out by Gregg.
Front barrel band is aluminum, made by Anthony, drilled by Rich and milled by me.

Quickster47



 Return to Index  

Sheridan Scope Mount

April 6 2012 at 5:19 PM
Chet  (Login chaiser)
Crosman Forum Member
from IP address 76.20.76.39


Response to Sheridan Scope

The most ideal scope mount for any Benjamin / Sheridan that I've run across is the mount that's sold by Harry Smith of Louisana. His phone number is 337-662-3610. He came up with the idea and has them built. It is made of black aluminum and takes away all the risk of barrel separation which can happen with the pair of intermounts that puts pressure on the barrel's solder joint when tightened and frequently causes separation. His mount clamps only on the barrel right in front of the breech and the dovetails extend back over the breech / bolt area and has a cutaway on the underside edge which allows ample room to load the pellet.
The dove tails that extend back over the breech allows one to use a standard scope without the need for a long eye relief unit. SUPER SANITARY. I've sold 10 or 12 of them and everyone is very pleased. There are two sizes. One size fits the 22 and 20 barrels and the other fits the 177.
If I can figure out how to post a pic, I'll do it. But give him a call.

 
 Respond to this message   
Responses

Crosman Corporation 1-800-724-7486

This forum is not affiliated with the Crosman Corporation in any way// Information presented in this forum is intended for informational purposes only; use at your own risk//Posts made to this forum are solely the opinion of the individual member