2260 with short crosman receiver atop a mini riser made from aluminum tube. Barrel is a 2200 soda straw
tensioned inside a titanium golf club shaft. Three screw mod to the trigger, bulk co2, SSP 250 rear cocking
striker assembly. Factory stock, reshaped, bedliner finish and stick on cheek piece. The idea was a weather
resistant light hunter for rainy days.
I've got a Cothran stainless receiver and gas tube waiting for me to get back to this one.
...but no power. If it was pumped up, it should have had some power.
Elsewise there are leaks. If you are considering tearing it down, consider this:
Squirt plenty of oil into the pump tube. Get it in there any way you can. Pump it several quick strokes and see if you gain good pressure that will hold. Sometimes that is all it takes to get the seals and valves functioning the way they had ought to.
The excess oil will eventually be shot out if that corrects the problem. If not,you can always tear down the gun.
This forum is not affiliated with the Crosman Corporation in any way// Information presented in this forum is intended for informational purposes only; use at your own risk//Posts made to this forum are solely the opinion of the individual member