The (new) Crosman Forum, your first and last stop for all things Crosman

CG01.jpg CG01.jpg

Carl Quick's LiteWieght 2240

So for about the last 24 months, I've had her on a serious diet. Now I am happy to report that she lost nearly 13 ounces and is feeling so much better. And let me say one thing, when I pick her up with one hand now she is light as a feather. Well, almost a feather.

Things I have done so far:

OEM main tube was lightened by me.
Barrel is OEM and trimmed down by me.
Main tube plug is made of Delrin by me.
Gas cap is aluminum, comes from HPA and bored out by me.
Hammer is made from Delrin by me with a modified 1701P striker.
Valve is an aluminum Disco rear end with a brass Pro-Top by Anthony.
Trigger grip frame is aluminum by Bluefork Design and then hogged out by Gregg.
Front barrel band is aluminum, made by Anthony, drilled by Rich and milled by me.

Quickster47



 Return to Index  

Forend for Benji/Dans

June 10 2012 at 8:13 AM
Greg Lundy  (Login BALLISTIC1)
Crosman Forum Member
from IP address 166.249.100.116


Response to 392 PA with a tootsie roll fore end?

I have thought it would be cool to make a new EXTENDED forend for a 392... My idea is to make a long round forend approximately 2" in diameter ringed like a pump shotgun... When I heard of Tims 'Tootsie Roll' forend/pump handle I thought "oh no, someboby else had the same idea"! The 'Tootsie Roll' pump handle is not new it was the moniker given to the original vintage Benjamin as a means of identification. The 'Tootsie Roll' pump handle is tiny in comparison to what I had in mind... Greg

Ballistic Enterprises #1 513 490 0035 "GO BALLISTIC!!!!" BE#1

 
 Respond to this message   
Responses

Crosman Corporation 1-800-724-7486

This forum is not affiliated with the Crosman Corporation in any way// Information presented in this forum is intended for informational purposes only; use at your own risk//Posts made to this forum are solely the opinion of the individual member