The (new) Crosman Forum, your first and last stop for all things Crosman

 photo 63f5b325-0274-4312-9dbd-2effde5b3715_zps0x27orls.jpg

Alan Alford's build

2250b Tube for later move to bulk CO2.
12" .22 Caliber Barrel from Doomsday Backpacker
Brian & Assoc. Alluminum Breech with 2 barrel screws
Original site rear
Pin site on Custom Mt. Airguns Muzzle Break
2x1 Centerpoint Scope with UTG dovetail adapters
Mountain Airguns Custom Bolt and Handle
Mountain Airguns Custom Power Adapter and spring guide
B&A Boss Valve for extra Power

Built mainly for fun and to shoot at local Field Trial Pistol Match.

It currently it shoots a 14.3 Crosman Hunting Pellet at about 530 fps in a 72 degree room for 8.92 FPE.



 Return to Index  

Moving heat from where it is not wanted is a wonderful thing

June 11 2012 at 2:51 PM
Cal  (Login CalG)
Crosman Forum Member
from IP address 24.128.138.174


Response to hehe Guess I can go home now

And friction can be both friend and foe.

Dragging the striker would be more effective than a spring buffer. The buffer is equal to a softer striker spring (not Eggs Actly, but close wink.gif Springs are very friction free energy storage devices.

Something compressible, but "dead" might be good...hmm Oil soaked blotter paper? leather? some material with useful elastic hysteresis?

Ideas are great!

cheers

 
 Respond to this message   
Responses

Crosman Corporation 1-800-724-7486
This forum is not affiliated with the Crosman Corporation in any way// Information presented in this forum is intended for informational purposes only; use at your own risk//Posts made to this forum are soley the opinion of the individual member