Crosman Airgun Forum (new): oy... Occam's Razor and BBQ in the same post

logo by smgunner

Return to Index

oy... Occam's Razor and BBQ in the same post June 14 2012 at 10:16 AM		(Login dan_house) Crosman Forum Member from IP address 153.90.162.47
Response to If it were possible, I'm not sure you'd like it.

hehehe ok, so piston arrestment is probably a bad thing. So we are back to Michael's well tuned springer. thanx guys! back to the lab....... dr_subsonic's pneumatic research lab the Lunatic Fringe of American Airgunning Southwest Montana's headquarters for Airgunning Supremacy Proud Sponsor of team_subsonic

Respond to this message

Responses

Yup. The only (documented) account of a springer debouncer... - Steve in NC on Jun 14, 2012, 10:47 AM

Had not even considered the deiselling effect - dan house on Jun 14, 2012, 12:07 PM

Dup. - Anonymous on Jun 14, 2012, 10:48 AM

So clean things up, Use Krytox to lubricate - Cal on Jun 14, 2012, 1:18 PM

Two pearls of experimental wisdom from "...Trigger to Target" suggest otherwise. - Steve in NC on Jun 14, 2012, 2:32 PM

Citations - Cal on Jun 14, 2012, 3:41 PM

Avoiding detonation - Curt on Jun 14, 2012, 5:18 PM

Interesting sidebar is that brass, steel, and aluminum particles are all combustible, and - Steve in NC on Jun 14, 2012, 6:19 PM

Ahh! For a bit of florine when you need it.... Passivation - Cal on Jun 14, 2012, 7:35 PM

Particles, as in powder... - Curt on Jun 15, 2012, 4:04 PM

Wear particles are exactly what I have in mind. You know the stuff... - Steve in NC on Jun 15, 2012, 4:58 PM

Re: Wear particles are exactly what I have in mind. You know the stuff... - Curt on Jun 15, 2012, 5:24 PM

I like the steam powered version!, Now that would be worth a try - Cal on Jun 14, 2012, 7:45 PM

Or, In the interest of investigation, fill with N2 - Cal on Jun 14, 2012, 7:41 PM

Did the N2 experiment tell all? - Ron on Jun 15, 2012, 9:01 AM

Ron Are you saying that water vapor, water in gaseous form, - Cal on Jun 15, 2012, 10:32 AM

I believe so - Ron on Jun 15, 2012, 1:45 PM

A mater of terms perhaps - Cal on Jun 15, 2012, 2:11 PM

Condensation during the firing cycle.... - rsterne on Jun 15, 2012, 2:13 PM

IF we could discharge into a vacuum, the gas would expand until it froze ;-) - Cal on Jun 15, 2012, 4:45 PM

Another reason that condensation is unlikely is the critical temp of water: 705F. - Steve in NC on Jun 15, 2012, 4:47 PM

Though this has nothing in common with the expansive situation in the barrel - Cal on Jun 15, 2012, 5:33 PM

Really? Please elucidate. At what point in a springer firing cycle... - Steve in NC on Jun 15, 2012, 6:11 PM

as soon as the pell leaves the muzzle! See above ref. to vacuum NT - Cal on Jun 15, 2012, 6:52 PM

LOL! My point, exactly, I.e., too late to be of any relevance whatever... - Steve in NC on Jun 15, 2012, 6:56 PM

I thought Ron was worried about rust... Oh Well ;-) - Cal on Jun 15, 2012, 6:59 PM

Ron Any effect due to water, vapor or steam, causes little change in the arresting of the - Cal on Jun 15, 2012, 5:40 PM

Perhaps the Arizona shooters could post chronometer numbers - Cal on Jun 15, 2012, 7:25 PM

Crosman Corporation 1-800-724-7486