photo toplogo1_zps46807118.jpg

 photo americlps_zpsavfgvdau.jpg

Dag Evert's "American Classic"

As mentioned on the forum, heres a picture I took some time back, with natural winter daylight.
A 2100, and a 1377, both guns have been recrowned, and had their trigger parts shimmed for play,
contact surfaces stoned, and trigger springs somewhat reduced within safe limits.
The 2100 has had its barrel shimmed with tape to remove play.
Both guns give great accuracy for the money if they are given good pellets!
The combination of pellets and guns in the picture represents something close to my boyhood dreams:-)
-- Dag Evert

 Return to Index  

I have a leak.

June 15 2012 at 9:41 PM
Mike  (Login lowridr)
Crosman Forum Member
from IP address 99.2.120.204

I used a 15" piece of 7/8" .065 cromoly tubing to bulk my 2240. I pressurized it to test for leaks and it seems to be leaking by the new Max flow valve face. If it were the valve seat, the leak would be coming out the barrel right? The leak is coming from the body. I polished the inside of the tube with fine steel wool on a stick in a drill. Came out very shiny. I also put some oil on all the O rings. Do I need to get a larger O ring?

 
 Respond to this message   
Responses

Crosman Corporation 1-800-724-7486
This forum is not affiliated with the Crosman Corporation in any way// Information presented in this forum is intended for informational purposes only; use at your own risk//Posts made to this forum are soley the opinion of the individual member