The (new) Crosman Forum, your first and last stop for all things Crosman

CG01.jpg CG01.jpg

Carl Quick's LiteWieght 2240

So for about the last 24 months, I've had her on a serious diet. Now I am happy to report that she lost nearly 13 ounces and is feeling so much better. And let me say one thing, when I pick her up with one hand now she is light as a feather. Well, almost a feather.

Things I have done so far:

OEM main tube was lightened by me.
Barrel is OEM and trimmed down by me.
Main tube plug is made of Delrin by me.
Gas cap is aluminum, comes from HPA and bored out by me.
Hammer is made from Delrin by me with a modified 1701P striker.
Valve is an aluminum Disco rear end with a brass Pro-Top by Anthony.
Trigger grip frame is aluminum by Bluefork Design and then hogged out by Gregg.
Front barrel band is aluminum, made by Anthony, drilled by Rich and milled by me.

Quickster47



 Return to Index  

photos of 1377 stemmed 2240 valve

June 22 2012 at 1:07 PM
zach allen  (Login sonargodz)
Crosman Forum Member
from IP address 138.163.106.72


Response to Chrono Results for 2240 Valve Extension and 1377 Valve Stem Exhuast Valve

Here you go in case you are interested. They flow alot more at higher pressures because of the reduced diameter of the stem and the poppet.


Here are a couple of photos of the valve with the 1377 stem installed:

[linked image]

[linked image]

If you are interested in the 1377 stemmed 2240 exhaust valve, it comes with a stem and the front half of the valve, shipped US Mail for $25. Antony's Pro-Top is not included........


 
 Respond to this message   
Responses

Crosman Corporation 1-800-724-7486

This forum is not affiliated with the Crosman Corporation in any way// Information presented in this forum is intended for informational purposes only; use at your own risk//Posts made to this forum are solely the opinion of the individual member