Carl Quick's LiteWieght 2240
So for about the last 24 months, I've had her on a serious diet. Now I am happy to
report that she lost nearly 13 ounces and is feeling so much better. And let me
say one thing, when I pick her up with one hand now she is light as a feather.
Well, almost a feather.
Things I have done so far:
OEM main tube was lightened by me.
Barrel is OEM and trimmed down by me.
Main tube plug is made of Delrin by me.
Gas cap is aluminum, comes from HPA and bored out by me.
Hammer is made from Delrin by me with a modified 1701P striker.
Valve is an aluminum Disco rear end with a brass Pro-Top by Anthony.
Trigger grip frame is aluminum by Bluefork Design and then hogged out by Gregg.
Front barrel band is aluminum, made by Anthony, drilled by Rich and milled by me.
part number?June 26 2012 at 5:24 AM
airgunandy (Login airgunandy)
Crosman Forum Member
from IP address 184.108.40.206
Anybody have the part number of the current black trigger being used on the 13xx guns? Is it the same number as the brass one (1300a007) or perhaps now it's 1300b007?
I've finally decided to take a pry bar to my bill fold and buy a steel receiver (breach) for my 2240 carbine. Since I'm going for the blacktical look, I might as well get rid of the brass trigger too, right?
I plink, therefore I am.
Crosman Corporation 1-800-724-7486
This forum is not affiliated with the Crosman Corporation in any way// Information presented in this forum is intended for informational purposes only; use at your own risk//Posts made to this forum are solely the opinion of the individual member