logo by smgunner
What I didJune 28 2012 at 3:42 PM
Crosman Forum Member
from IP address 18.104.22.168
Response to Anyone now the part# for a 1701P transfer port?
Sorta the poly-tube mod.
Took a piece of vinyl tube, cut to just a smidge longer than the stock port insert, then stuck a short piece of Ace hardware brass tube inside the vinyl.
I suppose one could take a piece of aluminum rod that just fits the vinyl snuggly, and drill it to whatever size port one desires to the same affect.
Found a slightly better seal at both the barrel and valve than stock, no tube distortion to screw up the air flow, and one can size it to whatever desired.
Crosman Corporation 1-800-724-7486