The (new) Crosman Forum, your first and last stop for all things Crosman


120_2001r.jpg

Scot Laughlin's Custom All Weather 2260

2260 with short crosman receiver atop a mini riser made from aluminum tube. Barrel is a 2200 soda straw
tensioned inside a titanium golf club shaft. Three screw mod to the trigger, bulk co2, SSP 250 rear cocking
striker assembly. Factory stock, reshaped, bedliner finish and stick on cheek piece. The idea was a weather
resistant light hunter for rainy days.
I've got a Cothran stainless receiver and gas tube waiting for me to get back to this one.

 Return to Index  

Have had trouble...

July 3 2012 at 3:30 PM
robert  (Login gubb33ps)
Crosman Forum Member
from IP address 68.105.50.68


Response to Well, to restate the basics. 1. A lighter striker will need a heavier...

..getting enough spring to speed a lite striker up to the point where is get back to the same energy as a heavy striker. Even taking some weight from the front end of the striker in order to lengthen stroke a bit hasn't fully made up the energy. Many just have a small area for a striker spring to operate, so when increasing striker tension, end up with a very stiff spring.



 
 Respond to this message   
Responses

Crosman Corporation 1-800-724-7486

This forum is not affiliated with the Crosman Corporation in any way// Information presented in this forum is intended for informational purposes only; use at your own risk//Posts made to this forum are solely the opinion of the individual member