The (new) Crosman Forum, your first and last stop for all things Crosman

CG01.jpg CG01.jpg

Carl Quick's LiteWieght 2240

So for about the last 24 months, I've had her on a serious diet. Now I am happy to report that she lost nearly 13 ounces and is feeling so much better. And let me say one thing, when I pick her up with one hand now she is light as a feather. Well, almost a feather.

Things I have done so far:

OEM main tube was lightened by me.
Barrel is OEM and trimmed down by me.
Main tube plug is made of Delrin by me.
Gas cap is aluminum, comes from HPA and bored out by me.
Hammer is made from Delrin by me with a modified 1701P striker.
Valve is an aluminum Disco rear end with a brass Pro-Top by Anthony.
Trigger grip frame is aluminum by Bluefork Design and then hogged out by Gregg.
Front barrel band is aluminum, made by Anthony, drilled by Rich and milled by me.

Quickster47



 Return to Index  

Question: Installing Disco Boss Valves

July 10 2012 at 10:36 AM
Jack Witas  (Login boomerdude)
Crosman Forum Member
from IP address 76.24.9.142

Anyone have any experience installing Disco Boss valves into air tubes. My O-rings keep getting chewed up on the Fill adapter threads. I'm using #016 rings with the proper silicon lube. Tried both Duro 90 and Viton rings. I don't have a problem with the gauge port assy and that uses the same size O-ring. This is driving me nuts!

 
 Respond to this message   
Responses

Crosman Corporation 1-800-724-7486

This forum is not affiliated with the Crosman Corporation in any way// Information presented in this forum is intended for informational purposes only; use at your own risk//Posts made to this forum are solely the opinion of the individual member