2260 with short crosman receiver atop a mini riser made from aluminum tube. Barrel is a 2200 soda straw
tensioned inside a titanium golf club shaft. Three screw mod to the trigger, bulk co2, SSP 250 rear cocking
striker assembly. Factory stock, reshaped, bedliner finish and stick on cheek piece. The idea was a weather
resistant light hunter for rainy days.
I've got a Cothran stainless receiver and gas tube waiting for me to get back to this one.
The problem is... it's not a problem for me to make it for me... the problem is to actually bring a needed or WANTED product to market... Andy, I have an INTEGRABASE Scoutmount with 'Baked enamel Finish'(spray painted and baked in the toaster oven) ready to send to you but I haven't found an appropriate shim material setup... If you want me to send it and you can work out the spacer or wait until I get something figured out is up to you.... Greg
This forum is not affiliated with the Crosman Corporation in any way// Information presented in this forum is intended for informational purposes only; use at your own risk//Posts made to this forum are solely the opinion of the individual member