2260 with short crosman receiver atop a mini riser made from aluminum tube. Barrel is a 2200 soda straw
tensioned inside a titanium golf club shaft. Three screw mod to the trigger, bulk co2, SSP 250 rear cocking
striker assembly. Factory stock, reshaped, bedliner finish and stick on cheek piece. The idea was a weather
resistant light hunter for rainy days.
I've got a Cothran stainless receiver and gas tube waiting for me to get back to this one.
ray1377 (Login ray1377) Crosman Forum Member from IP address 22.214.171.124
Discovery PCP to have the hammer cock separate from the bolt?
Sorta like Mr. Jack Haley does his big bores.
If you have done it, could you explain in detail the process of conversion and maybe post a few pictures?
Also, maybe state the cost and or parts involved in completing such a modification.
This forum is not affiliated with the Crosman Corporation in any way// Information presented in this forum is intended for informational purposes only; use at your own risk//Posts made to this forum are solely the opinion of the individual member