The (new) Crosman Forum, your first and last stop for all things Crosman


Jim Gillilan's Custom 1322 Carbine

Jim Gillilan's Custom 1322 Carbine w/Custom Stock

Here's one I'm especially proud of and is modded all over, doing 12fpe at 15 pumps.
Stock is Teak from Thailand and super light weight 1322 Carbine!

 Return to Index  

Yes, the Williams WGRS-54 will fit the 760, along with

April 23 2017 at 9:31 PM
John Thomas in Spokane  (Login jcl08)
Crosman Forum Member
from IP address 97.115.163.134


Response to Photo of 760 with Williams WGRS-54 and Higher Front Sight

almost any other airgun with 11mm. or 3/4" scope grooves, and it's my preferred peep sight for Crosman rifles with the grooved top because it just takes up a small area on top of the receiver with nothing overhanging the sides. The Williams 5D-AG low profile is my second choice but part of it does hang over the side of the receiver.

I sorry but I can't really recommend an online vendor though. I order from Pyramyd on rare occasions, but have never ordered sights from them. The only other airgun company I order from is Crosman, normally just from the parts Dept. but I have ordered a couple of their LPA MIM sights before.

Until recently I just bought Williams sights from a local gun shop that just went out of business, or from my cousin who is a gunsmith a few towns over. If I was going to order one myself I'd likely go through Midway, Amazon, or Cheaper Than Dirt.

For the front sights I make my own. I have access to my cousins lathe, and also just picked up my own. I turn out my own muzzle weights (about the same as on the 760 in your link above) and drill and tap them for ether pin posts that I also make myself, or for random, used screw mount ramp or globe front sights that I get from my cousin or at gun shows.

 
 Respond to this message   

Crosman Corporation 1-800-724-7486

This forum is not affiliated with the Crosman Corporation in any way// Information presented in this forum is intended for informational purposes only; use at your own risk//Posts made to this forum are solely the opinion of the individual member