The (new) Crosman Forum, your first and last stop for all things Crosman

Jim Gillilan's Custom 1322 Carbine

Jim Gillilan's Custom 1322 Carbine w/Custom Stock

Here's one I'm especially proud of and is modded all over, doing 12fpe at 15 pumps.
Stock is Teak from Thailand and super light weight 1322 Carbine!

 Return to Index  

That was my take, especially considering that due to the difference...

April 29 2017 at 9:35 PM

Steve in NC  (Login pneuguy)
Crosman Forum Member
from IP address

Response to Ok, that makes sense... the respective radii of the arcs they move in relative to the area of contact, there's a good deal of sliding friction between lobe and sear. Seemed like that would require a fairly accurately linear profile of the new surface if you chose to reshape the sear and expected smooth movement.

A glance at the photo above suggests how likely accurate linear profiles would have been. LOL!

 Respond to this message   

Crosman Corporation 1-800-724-7486

This forum is not affiliated with the Crosman Corporation in any way// Information presented in this forum is intended for informational purposes only; use at your own risk//Posts made to this forum are solely the opinion of the individual member