The (new) Crosman Forum, your first and last stop for all things Crosman


Jim Gillilan's Custom 1322 Carbine

Jim Gillilan's Custom 1322 Carbine w/Custom Stock

Here's one I'm especially proud of and is modded all over, doing 12fpe at 15 pumps.
Stock is Teak from Thailand and super light weight 1322 Carbine!

 Return to Index  

re 130

April 30 2017 at 8:31 AM
Bob in WV  (Login duhuh)
Crosman Forum Member
from IP address 50.110.95.139


Response to Crosman Model 130

I have resealed a few of those guns and they are pretty easy to work on. It has been a long time though and I can't remember any tricks. It may have a quad seal and they are a little tricky to get out but not that bad. You can get a schematic from the Crosman site and go at it. Just use proper fitting screwdrivers and punches and you should not mark it up.

Most of all have fun learning about that gun, good luck,
Bob in WV
Never get in a hurry, it only slows you down.

 
 Respond to this message   
Responses

Crosman Corporation 1-800-724-7486

This forum is not affiliated with the Crosman Corporation in any way// Information presented in this forum is intended for informational purposes only; use at your own risk//Posts made to this forum are solely the opinion of the individual member