The (new) Crosman Forum, your first and last stop for all things Crosman


Jim Gillilan's Custom 1322 Carbine

Jim Gillilan's Custom 1322 Carbine w/Custom Stock

Here's one I'm especially proud of and is modded all over, doing 12fpe at 15 pumps.
Stock is Teak from Thailand and super light weight 1322 Carbine!

 Return to Index  

SSP pump unit demonstration...Video...

June 11 2017 at 5:48 PM
Phil  (Login Duane35)
Crosman Forum Member
from IP address 76.120.212.220

Pretty self explanatory in the video, I think. As it is, it is extremely loud and has enough blast out the transfer port to move the assembly while holding it. We shall see what happens when pushing pellets. As configured in the video, it is compressing 8.5 cu.in. of air to roughly 2000psi.

Many have expressed concerns over piston vacuum on the open stroke. This design uses no weep hole on the tube to draw air in. Instead, there is a weep on the piston face near the radius. The oring gland is designed just like many, if not most, PCP pumps. Pulling the piston back on the open stroke force the oring toward the face exposing the weep hole, thus allowing air in. To achieve this, the gland is cut 1.75 times the width of the oring and then using a Delrin made spacer to fill the excess void. The spacer prevents the oring from too much movement within the gland.


https://youtu.be/89ky3M1DCIc


    
This message has been edited by Duane35 from IP address 76.120.212.220 on Jun 11, 2017 7:36 PM


 
 Respond to this message   
Responses

Crosman Corporation 1-800-724-7486

This forum is not affiliated with the Crosman Corporation in any way// Information presented in this forum is intended for informational purposes only; use at your own risk//Posts made to this forum are solely the opinion of the individual member