The (new) Crosman Forum, your first and last stop for all things Crosman


Jim Gillilan's Custom 1322 Carbine

Jim Gillilan's Custom 1322 Carbine w/Custom Stock

Here's one I'm especially proud of and is modded all over, doing 12fpe at 15 pumps.
Stock is Teak from Thailand and super light weight 1322 Carbine!

 Return to Index  

Re: Anyone ever drill and tap a Crosman hammer ?

June 12 2017 at 9:05 AM

Mike T.  (Login TKO22)
Crosman Forum Member
from IP address 107.77.85.23


Response to Anyone ever drill and tap a Crosman hammer ?

You can drill a Crosman hammer with a carbide bit, but you WILL break a tap, carbide or otherwise... unless you anneal the hammer first.

Take the back half to cherry red 3 times with a slow cooling period between.

Been there, ruined that!

Mike

 
 Respond to this message   
Responses

Crosman Corporation 1-800-724-7486

This forum is not affiliated with the Crosman Corporation in any way// Information presented in this forum is intended for informational purposes only; use at your own risk//Posts made to this forum are solely the opinion of the individual member