The (new) Crosman Forum, your first and last stop for all things Crosman


Jim Gillilan's Custom 1322 Carbine

Jim Gillilan's Custom 1322 Carbine w/Custom Stock

Here's one I'm especially proud of and is modded all over, doing 12fpe at 15 pumps.
Stock is Teak from Thailand and super light weight 1322 Carbine!

 Return to Index  

Re: Anyone ever drill and tap a Crosman hammer ?

June 17 2017 at 3:00 PM
ped   (Login --ped--)
Crosman Forum Member
from IP address 90.216.250.155


Response to Anyone ever drill and tap a Crosman hammer ?

hammers are easy to drill for threaded pins
just grind a off the case hardening and the steel underneath is as soft as butter so drill and tap as normal but watch out when the drill and tap gets to the spring bore as that'll still be case hardened
if you're fitting an adjustable striker use a carbide burr to remove the hardened surface and then drill and tap as normal in your lathe

 
 Respond to this message   
Responses

  • Thanks Ped - Mitch on Jun 18, 2017, 3:48 PM
  •  
  • nt - cobalt on Jun 20, 2017, 1:29 PM
  •  

Crosman Corporation 1-800-724-7486

This forum is not affiliated with the Crosman Corporation in any way// Information presented in this forum is intended for informational purposes only; use at your own risk//Posts made to this forum are solely the opinion of the individual member