The (new) Crosman Forum, your first and last stop for all things Crosman

CG01.jpg CG01.jpg

Carl Quick's LiteWieght 2240

So for about the last 24 months, I've had her on a serious diet. Now I am happy to report that she lost nearly 13 ounces and is feeling so much better. And let me say one thing, when I pick her up with one hand now she is light as a feather. Well, almost a feather.

Things I have done so far:

OEM main tube was lightened by me.
Barrel is OEM and trimmed down by me.
Main tube plug is made of Delrin by me.
Gas cap is aluminum, comes from HPA and bored out by me.
Hammer is made from Delrin by me with a modified 1701P striker.
Valve is an aluminum Disco rear end with a brass Pro-Top by Anthony.
Trigger grip frame is aluminum by Bluefork Design and then hogged out by Gregg.
Front barrel band is aluminum, made by Anthony, drilled by Rich and milled by me.

Quickster47



  << Previous Topic | Next Topic >>Return to Index  

crosman phantom trigger

May 3 2012 at 6:34 PM
justin  (Login blueshorts)
Crosman Forum Member
from IP address 75.145.153.237

i was looking at the trigger on my gun and a thought crossed my mind. wouldnt the trigger have to have two contact points with the strut to make it a two stage trigger. and if so then the one on my gun is technically a single stage trigger. can some one prove me right or wrong on this.

 
 Respond to this message   
AuthorReply
Curt
(Login curt44319)
Crosman Forum Member
66.181.110.200

Re: crosman phantom trigger

May 3 2012, 7:10 PM 

No, two contact points are not necessary.
It's all about the feel.

A two stage trigger has two distinct pull weights.
The first is relatively light. Could be just a return spring on the trigger before
it contacts the sear.
The second stage is noticeable heavier, and generally quite short.
When you hit the second stage, you know that the gun is about to discharge.
Useful for target. You "take out the slack"through the first stage, then when the trigger
gets tight, you hold target, and fire.
For rapid fire, defense, etc. not so useful.

My personal preference for just about all cases is a relatively light single stage,
with almost zero take up, and very little over-travel, typically called a "hair" trigger.
( you could call it two stage, with zero weight on the first stage ( before my finger contacts the shoe ) )

I do prefer a two stage on double-action. First stage cock, and second stage fire,
with distinct pull weights, heavy of necessity.


    
This message has been edited by curt44319 from IP address 66.181.110.200 on May 4, 2012 5:12 AM


 
 Respond to this message   
 
  << Previous Topic | Next Topic >>Return to Index  

Crosman Corporation 1-800-724-7486

This forum is not affiliated with the Crosman Corporation in any way// Information presented in this forum is intended for informational purposes only; use at your own risk//Posts made to this forum are solely the opinion of the individual member