I kinda want to dissassemble my airmaster, and lube, tune it, and perform any mods that can be done.

Ive searched but havent really found alot.

Anything I should do specifically?

Also if any of you modified your airmaster 77 in any way, help is apprecaited.


Thanks

Check the forum index at the top of the main page. There is a link on the left side of the page I believe to a "How-to" on tuning the 2200. The 2200 is the now discontinued .22 caliber version of the 2100/77.

Edit: Was finally able to get to the index page, so here's the link...
http://www.network54.com/Realm/CFTech/FB2200.htm


I plink, therefore I am.

When you get it separated, be sure to take good pictures to document the springs and levers.

Also, these are a bear to get back together. It takes at least 3 hands to do it. I did it, so it is doable. I really do not want to do it again though.

Good Luck,
Packrat1947

www.pbase.com/packrat

If you follow how the mods are done as described for the 2200 you should be happy with the results . Even after getting frustrated putting it back together .lol
No. It's not bad . Just take your time and be patient . At least that's what I'm telling myself for tomorrow, as mine won't shoot out the air I pumped into it today .

I did quite a few mods to my AM77. Check the following for a summary..
http://www.network54.com/Forum/79537/thread/1296033681/Crosman+versus+Daisy
Search "A4Skyhawk" for earlier posts on my project - got a lot of help from this forum.
HTH,

A4Skyhawk