"i never was much for book learnin"

Not enough clearance on top of the breech to cut the slot for the mag to slide thru.

 

dr_subsonic's pneumatic research lab

the Lunatic Fringe of American Airgunning
Southwest Montana's headquarters for Airgunning Supremacy
Proud Sponsor of team_subsonic

LOL!!!

I plink, therefore I am.

"i never was much for book learnin"

i keep thinking of ways to make one like it for the crosman breech

Current add on breech sells for 120 ish..too much to invest in 50 dollar pistol like the 1377 imo.


"i never was much for book learnin"

to fill in xtra space than to cut it

760 is only 5 shots though,

dr_subsonic's pneumatic research lab

the Lunatic Fringe of American Airgunning
Southwest Montana's headquarters for Airgunning Supremacy
Proud Sponsor of team_subsonic

Think outside the rotory mag!
Just cut the handle off one 760 mag and glue that mag to another mag. Now you have 10 shots. Add a third one for 15, but that would become rather awkward to use....

I plink, therefore I am.

small finder spring to hold the pellet, and a large knob to push on for the next shot.

Now that might be doable.

dr_subsonic's pneumatic research lab

the Lunatic Fringe of American Airgunning
Southwest Montana's headquarters for Airgunning Supremacy
Proud Sponsor of team_subsonic

Maybe O-rings in the mag to locate the pellets?

I plink, therefore I am.

would make the 760 better

dr_subsonic's pneumatic research lab

the Lunatic Fringe of American Airgunning
Southwest Montana's headquarters for Airgunning Supremacy
Proud Sponsor of team_subsonic

What about belt feed? Load the whole can of pellets in one or two belts and pull them through rather than push. LOL

I plink, therefore I am.

may i add a twist to this?? an auto feed that advances the mag with each cycle of the bolt?

"i never was much for book learnin"