The (new) Crosman Forum, your first and last stop for all things Crosman


Jim Gillilan's Custom 1322 Carbine

Jim Gillilan's Custom 1322 Carbine w/Custom Stock

Here's one I'm especially proud of and is modded all over, doing 12fpe at 15 pumps.
Stock is Teak from Thailand and super light weight 1322 Carbine!

  << Previous Topic | Next Topic >>Return to Index  

Pump cup

May 17 2017 at 3:00 PM
Luckystrike   (Login lee5868)
Crosman Forum Member
from IP address 73.230.242.149

Hey Guys and Gals,

I am currently trying to rebuild a Crosman 101. I have it all resealed so far except for the pump cup. Can anyone give me tips or tricks on how to replace the pump cup? I have a baker airguns reseal kit.

Thanks lucky

 
 Respond to this message   
AuthorReply
Wayne
(Login WayneCNY)
Crosman Forum Member
75.104.3.167

Pump Cup

May 18 2017, 11:49 AM 

The Mac-1 pump head is the way to go with these guns. Not having this set up, I would make puller out of a flat washer to get the pressed on brass piece off. The older screw on retainer (leather pump head) does not work so well with the rubber pump cup. Hope this helps.

 
 Respond to this message   
 
  << Previous Topic | Next Topic >>Return to Index  

Crosman Corporation 1-800-724-7486

This forum is not affiliated with the Crosman Corporation in any way// Information presented in this forum is intended for informational purposes only; use at your own risk//Posts made to this forum are solely the opinion of the individual member