The (new) Crosman Forum, your first and last stop for all things Crosman


Jim Gillilan's Custom 1322 Carbine

Jim Gillilan's Custom 1322 Carbine w/Custom Stock

Here's one I'm especially proud of and is modded all over, doing 12fpe at 15 pumps.
Stock is Teak from Thailand and super light weight 1322 Carbine!

  << Previous Topic | Next Topic >>Return to Index  

Lubing internal PCP parts

June 1 2017 at 12:26 PM
Mike  (Login Mike17670)
Crosman Forum Member
from IP address 50.76.58.195

Hey Guys,
What is the best way of making sure all internal parts are lubed. I would like to minimize the effects of moisture created during filling.
Thanks

Mike

 
 Respond to this message   
AuthorReply
BillK
(Login BillKE4)
Crosman Forum Member
24.247.59.143

Silicone divers grease on the Orings and nothing

June 3 2017, 7:27 AM 

else. Absolutely no petroleum based lube should be used in the air tube as it will "diesel" under pressure and blow up. At least that is what I have gleaned from much reading about PCPs.
I'm no expert so be sure to follow the manufactures directions.


    
This message has been edited by BillKE4 from IP address 24.247.59.143 on Jun 3, 2017 7:32 AM


 
 Respond to this message   

dan_house
(Login dan_house)
Crosman Forum Member
153.90.51.122

parts not in the air tube can be lubed....

June 6 2017, 1:31 PM 

metal to metal parts should be buffed smooth and a little moly or yer favorite AR15 lube BURNISHED in

you should deburr the entire air tube too, it'll help reduce cutting oring during take downs and reassembly

 
 Respond to this message   
 
  << Previous Topic | Next Topic >>Return to Index  

Crosman Corporation 1-800-724-7486

This forum is not affiliated with the Crosman Corporation in any way// Information presented in this forum is intended for informational purposes only; use at your own risk//Posts made to this forum are solely the opinion of the individual member