The (new) Crosman Forum, your first and last stop for all things Crosman


Jim Gillilan's Custom 1322 Carbine

Jim Gillilan's Custom 1322 Carbine w/Custom Stock

Here's one I'm especially proud of and is modded all over, doing 12fpe at 15 pumps.
Stock is Teak from Thailand and super light weight 1322 Carbine!

  << Previous Topic | Next Topic >>Return to Index  

Crosman 140 pumping problem

June 13 2017 at 5:34 PM
PaulP  (Login PaulP)
Crosman Forum Member
from IP address 75.64.123.9

Hey! I recently rebuilt a 140, over the weekend I was checking the fps with a chronograph, 3 pumps, 6 pumps and 10 is where the problem popped up. The lever rivet broke, I fabricated a steel rivet , the pump lever is working fine but it stops short of closing, it is like it is binding on something. I checked to see if there was a bend in the pumping lever, none. Then I disassembled the gun and everything looked ok, I still can not get the pump am to close. Any ideas ?

 
 Respond to this message   
AuthorReply
Ronald
(Login GunNut10)
Crosman Forum Member
104.12.88.15

Adjust the pump (piston) rod.....NT

June 13 2017, 5:57 PM 



    
This message has been edited by GunNut10 from IP address 104.12.88.15 on Jun 13, 2017 6:01 PM


 
 Respond to this message   
PaulP
(Login PaulP)
Crosman Forum Member
75.64.123.9

Adjust the pump (piston) rod

June 13 2017, 6:57 PM 

10-4 Thanks for the reply

 
 Respond to this message   
 
  << Previous Topic | Next Topic >>Return to Index  

Crosman Corporation 1-800-724-7486

This forum is not affiliated with the Crosman Corporation in any way// Information presented in this forum is intended for informational purposes only; use at your own risk//Posts made to this forum are solely the opinion of the individual member