Does Doc drill the eye for the eblade and if he does will he end up drill for the break beam eyes for the eblade 2?

also what else am i gonna have to get when i get this body? a front block a ivg what else?

every thing that you need on a reguler cocker
ASA screw good luck fineing one lol
that the hard one but every thing els is ezy
Sky

Just do what I did- look through your screw collection (I've got a few of those big cans of peanuts full of various screws), find one with the right threads and dremel down the head until it slides into the guide hole and tightens down enough to hold the ASA securely. Or just go to a hardware store and find the same thing.

Devman

go to madcocker .com and just get a kapp screw kit or the wgp one

okay now what about the eye situation????

Given that the E2 isn't out yet...? He can't drill for something he hasn't seen yet, bro. Furthermore, the breakbeam eyes will not be out for some time AFTER the release of the E2 kit, which comes with a reflective eye (READ: NOT THE BREAK-BEAM EYES). Everyone's in a tizzy about the E2 and it isn't even out yet. Chill, bro. The Eblade has been just fine up until now, I think you can deal with having an IR Eye for a little while longer.

BTW- Projected release of the break-beams is much later than the E2 release. So no, there's no point to waiting for it if you're building an E-cocker.

Devman

well being that i wasnt gonna get this body for probably 7 months i was just wondering for the long run......

sio i'm actually gonna keep my E1 and the gun i have now and buy an E2 kit and this body and everything else i need... so i'l have two great e-cockers