hey this is a quick query. i have a new e2 on my fastback but i cant seem to get the rof over 12 bps . i have the setting on factory fast but still it will not cycle any faster. This new tt filter seem to be limiting rof. I am not sure how to work around this issue. i am tired of reading reviews about people getting 18 bps off this grip. i dont think that its me either i can walk my other fastback at well over 15 bps. If any of the cocker masters out there have ideas for me i would really be greatful.

what loader u using?? if u r shooting it with the eye off then it caps at 12 bps. if the eye is on then it shoots as fast as ur loader allows without chopping

i don't know if matters which loader i am using . i am dryfiring it in both semi and the new training mode. but still the ROF seems to cap at 12 bps. i am not sure if running paint will increase my rof. i am wondering if it has something to do with the general setup of the grip. i have it set on factory fast, maybe with a fasty it needs a custom setup. thanks for the input

if u dry fire, it caps at 12 bps unless u change the settings. i think i said that in the above post

no, there is no cap at all dry fire or not. The tt filtering helps eliminate bounce which the eblade was notorious for. Adjust your trigger some to find the right feel. After a little tunning on trigger you should be able to hit 15-16 with a lil practice. You can make it bounce by playing with the tt filter but I would not recomend this. Lower your tpul and trel to 1 and 2.
This will also help some.

I would not say that it is "capped", but on factory fast with the eye off it is only capable of 12 bps. I had the same issue when i got my e2, and got it going much faster after tweaking some settings. The eye on "overrides" certain settings, allowing it to shoot faster (as fast as your hopper) on factory fast. Set your trel and tpul to 1, and shorten your ttband and raise yout ttolerance.

just lower the tpul and trel down to 1 and 2, this will help alot. Leave the tt filters alone

it really doesn't cap at 12 bps with the eye off, its just your settings is all it is. try these settings with the eye off next time

sear on: 3
cdel:3
con:32
cto:230-255
coff:19

its because factory fast is slow... it maxes at 12ish.... go into settings and do ur own custom settings
heres what i have in mine:
sear on-2.5
c del- 3.6
c on- 47
c t/out-1
c off- 20
the rest of the settings i have set at stock

basically when you time your eblade the only settings that matter for the rof is the c delay, c on, and c off. to see how fast you are shooting all you do is add all three of those numbers up then take 1000 and divide by the sum of the three settings.

Woota fukin MORON you are, read the damn instructions & you'd know its capped when the eyes are off

it is capped, i know a wgp tech "big mike" and i asked him, the eblade is capped if the eyes are off at 12. mine hits 19

one of a kind e2 mint green karnivor
www.myspace.com/flowmaster for pix of it

Its not capped. Its the settings. Eye overrides the settings that are responsible for the bolt opening and closing. With the eye on, it will only shoot as fast as the hopper loads.

If your not using the eye, you have to time it. Its basically the same as timing your non ecocker cept bit more advance and you can do a bit of math to figure out things.

There are some setting you can mess with that will effect shooting with eye on. Basically, you can overcome some of the hoppers limitations by making the bolt go back as soon as possible after firing, to create a vacuum in the breech to suck the ball in.

I doubt you got 15 balls a sec with a swing trigger, unless you got the fastest finger known to man, and even if you had supermans fingers, how did you measure this phenomenal feat? unless you have bounce i highly doubt 15 non e. you have to have a full pull!!! SHIT, even on my eblade, e2 zerob 1.20, in semi mode with the settings so i can fire as fast as i can humanly hit the trigger, I cannot get bast 10. walking or just spazzing my fingers out lol. I have to use ramping to achieve higher rof.

EAZY WAY TO GET IT SHOOTING FAST.

Buy a fast hopper like a halo b, and turn the eye on. Put it on ramping 1 and go nuts.