Return to Index  

Ed, cut the hull and deck by 3/8" and build a

August 15 2009 at 2:58 PM		   (Login PBR66)
HyperScale Forums
from IP address 68.99.47.141


Response to Gato issues
Tambor class sub. Especially since the Tambors had an all wood deck and anchors on both sides...as in the Trumpter kit. Might be wise to measure the kit's hull. Gato should be 26" in 1/144. Tambor would be 25 5/8".
This conversion would be a WHOLE LOT EASIER THAN 1/72.
Ken

 
 Respond to this message   

Please note a few points of etiquette. First, would all contributors please use their real name and/or their actual e-mail address. All contributions are welcome but please refrain from political or abusive comments. These posts will promptly be removed from the server.

In addition, Ship Chat is not a forum for the public criticism of the models that appear as Galleries or Articles on HyperScale. Please make any suggestions for improvements or criticism direct to the author via the email link at the bottom of the Article.

Finally, please note that this Discussion Group is privately operated and that I reserve the right to delete any post for any reason whatsoever.