Sniperdad69 (Login sniperdad69) from IP address 70.158.137.245
Comparison between original Valve, and Hammer spring/ To new setup, LOL
I think the Wife will like what I did for Mothers Day.
I may as well start on breakfast now. (Or I could give it a couple hours, It is only 2:00am)
Cheers, David.
That is a handle. the spring is so heavy, that I need something to pull on, LOL.
May 11 2008, 1:55 PM
The hammer is heavy, and Lots of Spring. It is through the Brass fittings to the Black end cap.
The bolt and handle, and end cap all move with the hammer, for additional weight.
It will dump 2250psi of pressure, where a normal set up will only dump 1000psi.
I will chrony it soon.
Cheers, David.
You need a special lever to pull back that Monster spring!!LOL
Almost like the hammer springs of the BigBores. If you keep up
the power on that thing I can see you getting a 308 barrel and
turning that 22XX into a mid range coyote carbine. Keep posting.
Thanks Mig Rod. The Hammer and Spring is almost on par with my 201 Fire 9mm
May 12 2008, 9:56 AM
At the moment it is set up for 1400psi with a 14" barrel, I get 3 shots from a bulked 2260 airtube:
875.9
787.8
703.6
So I need a serious Airtank to keep it filled.
I also know that Valvelock is not a problem for a lot more air.
I need to figure out what to use it for, and then tune it to that purpose.
18fpe is good for a Squirrel gun 14"barrel, light and quick to shoulder.
or 40fpe for groundhogs, LOL
