It didnt hurt bad till i rinsed it, then i said to myself" **** this isnt good".. being a former nys EMT i kept a cool head., but i have a lurking suspicion im gonna be getting stiches tomorrow.. pics soon.


"i never was much for book learnin"

then no pain right? Duct tape some paper towel around it  and keep it dry for a couple days.

cmon Rob walk it off

hehehe

serisouly, what did you do

dr_subsonic's pneumatic research lab

the Lunatic Fringe of American Airgunning
Southwest Montana's headquarters for Airgunning Supremacy
Proud Sponsor of team_subsonic

Then scotch tape paper towel lol..its properly bandaged today..cant say what happened, too embarrassed.


"i never was much for book learnin"

it stings a little but it will hold the skin together..............:-D

Tried to remove a long aluminum stringer off the lathe before the chuck came to a stop....bad Idea...got caught in the spinning chuck an bout took the tip of my trigger finger off. Aluminum does not break off into little chips, they end up as long spiral razor blades, you don't want to mess with them.

Used some antibacterial wash that was labled "no sting". They lied.

Keeping a typical bandage on a finger that gets soaked with cutting fluid is impossible, so yes, use superglue. I guarantee you it will sting, and it wont last forever, but it will hold it shut.

Jim

Seen those strings, i steer clear...


"i never was much for book learnin"

trying to cut 1" thick aluminum with a jigsaw??

No...didnt attempt that idea


"i never was much for book learnin"