I don't see posts to classifieds here much, so sorry if that is taboo here, but this one was just too topical and may be a rare opportunity to get hard to find parts. I wonder if it's the double-rare Canadian model, lol?
After beating the 352 out to a 4.05" bore it's pretty much done as far as I'm concerned... Maybe good as a daily driver engine though
That Edsled is very similar to that Starliner I had... Wondering (a bit too late ) if the stalinless was similar?
The top link is the add I was posting; the bottom one is actually a link to my supermotors site that shows up as my signature--that 352 is mine
a little known fact about the 352 is that they have the same block casting as a 390 and just have a smaller bore from the factory. They can often go 4.05 or bigger and still have decent cylinder thickness. I had a sonic check of mine before it was bored and it is .125 pretty much everywhere even after the overbore.
