The last time...May 14 2011 at 1:55 PM
No score for this post
from IP address 220.127.116.11
Response to the pic
I removed the rotating bezel from a watch similar to yours, I used a kitchen knife with a sharp edge and the handle of a screw driver as a mallet. I placed the case, 9 o'clock side down, against a table top and then carefully inserted the edge of the knife blade into the seam between the bezel and the case near the 3 o'clock position. Several taps of the top edge of the knife blade with the screw driver's handle made the bezel pop off of the case. Any scratching of the case that might occur will be hidden when the bezel is reinstalled later.
These bezels, regardless of whether or not they are unidirectional, are held in place by a sort of tension spring that expands under a circular ridge to hold the bezel to the case. The tension spring is designed to compress just enough to allow the bezel to pop off of the case when a wedge is driven into the seam between the bezel and the case.
To reinstall the bezel back onto the case, simply press it into place by squeezing down on opposite sides of it with your thumbs.
Generally, you do not need special tools to removing and replace rotating bezels.