Re: A little tech help (Help!)May 15 2012 at 10:38 PM
No score for this post
|George S |
from IP address 188.8.131.52
Response to A little tech help (Help!)
Its been a long time since I fiddled with one of these so take my advice with a grain of salt, but here goes. As I recall, I had an issue getting the pin in the fork but then realized that it did not need to go in. Rather it finds its way in after assembly.(See manual page 50.9.) I do not recall the best initial position of the fork but I think it should be to the right (counterclockwise), but it may not matter. Caution: This advice is probably worth what you are paying for it.