Hi Admin
In 20th May, I feedback the forum encoding problem as following:
I have a forum and the posters are in Chinese.
Address:
http://www.network54.com/Forum/25750/
When I visits the page, the page encode is ISO by default. And all the Chinese characters are shown as error codes.
I use "click right button" - "Encode" - "Simplied Chinese GB2312", the character can be shown normally.
But when i refresh the page or click into a thread, the same probelm of "ISO by default and content in error code" happen again. And I have to repeat the encode change step every time.
How can I resolve the problem?
In 25th May, customer supporter feedback that technical team will take this issue.
In 28th May, I followed and hope to know if anyupdated information about it but there is no answer until now.
Please refer to the following thread for detail
http://www.network54.com/Forum/44985/thread/1274367403/page+encode+problem
I have searched for encoding and found that some Hongkong and Japanese forum have meet the similar problem and get resolved soon.
Sorry for opening another thread for attention. I just wish to know if the problem can be resolved and the estimated time.
Thanks and Best Regards.
