Home > Discussion Groups > Axis

 

Message posting guidelines:

  • Full real names must be used at all times.

  • A valid e-mail address must be provided. (This is not optional)

  • Images must be posted at low resolution (72 dpi) and no larger than 760 pixels wide, and copyright/trade mark owners must be credited whenever reasonably possible.

  • Registration is compulsory if you wish to post messages on the Discussion Groups. For further information, please see the following message: http://www.network54.com/Forum/message?forumid=47207&messageid=1113822984

Please read our Community guidelines before posting.

By contributing to this discussion group, you indicate your agreement to the Terms and Conditions of Use.

Posts that violate the guidelines or Terms and conditions of Use of the Missing-lynx.com discussion groups will be erased, and repeated violation of this policy may result in termination of the violator's account.


Advertisement

 Return to Index  

Placing a siG33 on a Bison I

July 4 2009 at 11:23 AM		   (Login ericreits)
Missing-Lynx members
from IP address 81.207.7.183
Just bought Dragon's nicely detailed Bison I (6259) and I would like to dismount the SiG33 gun. How was it normally installed? I have one picture of a crane but would it be possible to pull the gun backwards, adding two bars/U shaped bars from the end of the engine deck to the ground, similar to the Demag SdKfz10 when the flak was removed? And the superstructure should be removed too I guess due to the wheels...?

regards,

Eric


 
 Respond to this message   
Responses

  1. Re: Placing a siG33 on a Bison I - Darren Thompson on Jul 4, 11:45 AM
    1. Turning it lightly - Guillem Martí i Pujol on Jul 4, 12:57 PM
      1. Ah, that's interesting - Robert Lockie on Jul 4, 2:20 PM
        1. I did my plans - Guillem Martí i Pujol on Jul 4, 8:03 PM
     


Terms and Conditions of Use Report abuse