Home > Discussion Groups > Axis

Message posting guidelines:

  • Full real names must be used at all times.

  • A valid e-mail address must be provided. (This is not optional)

  • Images must be posted at low resolution (72 dpi) and no larger than 760 pixels wide, and copyright/trade mark owners must be credited whenever reasonably possible.

  • Registration is compulsory if you wish to post messages on the Discussion Groups. For further information, please see the following message: http://www.network54.com/Forum/message?forumid=47207&messageid=1113822984

Please read our Community guidelines before posting.

By contributing to this discussion group, you indicate your agreement to the Terms and Conditions of Use.

Posts that violate the guidelines or Terms and conditions of Use of the Missing-lynx.com discussion groups will be erased, and repeated violation of this policy may result in termination of the violator's account.


Advertisement

 Return to Index  

Griffon or do it your self

March 6 2012 at 3:33 AM		Jari Lievonen  (Login JariL)
Missing-Lynx members
from IP address 212.213.184.110


Response to Grille H crew floor question.
Hi,

Griffon has an etched set that has the floor plates and the stowage boxes underneath included. The other alternative is to scratch build the floor by usig Aber, Eduard etc. diamond pattern plate.

The gun pedestal is a bit too low in the kit so remeber to add some height under it.Makes it easier to fit the gun in place too. Unfortunatelly I don't remember weather it was 1 or 2 mm that was needed but please refer to photos.

Regards,

Jari


    
This message has been edited by JariL from IP address 212.213.184.110 on Mar 6, 2012 3:33 AM


 
 Respond to this message   
Responses

  1. Thanks for the info.... - Kingston Wong on Mar 7, 1:03 AM
    2.  


Terms and Conditions of Use Report abuse