Home > Discussion Groups > Axis

Message posting guidelines:

  • Full real names must be used at all times.

  • A valid e-mail address must be provided. (This is not optional)

  • Images must be posted at low resolution (72 dpi) and no larger than 760 pixels wide, and copyright/trade mark owners must be credited whenever reasonably possible.

  • Registration is compulsory if you wish to post messages on the Discussion Groups. For further information, please see the following message: http://www.network54.com/Forum/message?forumid=47207&messageid=1113822984

Please read our Community guidelines before posting.

By contributing to this discussion group, you indicate your agreement to the Terms and Conditions of Use.

Posts that violate the guidelines or Terms and conditions of Use of the Missing-lynx.com discussion groups will be erased, and repeated violation of this policy may result in termination of the violator's account.


The problem is...

May 29 2012 at 4:58 AM
Erich Christ  (Login trex10)
Missing-Lynx members
from IP address

Response to Sd.Kfz 222 Steering

... that both Tristar and even Bronco´s Sdkfz 221 are wrong with their rear steering system.
Both modelproducers shows the Horch chassis 801, where the rear steering linkeage is behind the rear axle, below the oil cup.
In fact they have reproduced the rear steering of the later, reinforced Horch chassis 801V(verstärkt = reinforced) put in production in May 1942, where the rear steering linkeage is in front of the rear axle. So probably thats the reason why it dont works properly.

I am just collecting all technical datas to start with the Tristar and Bronco Sdkfz 221, so have not yet checked this detail about the wrong steering angle.

 Respond to this message   

Terms and Conditions of Use
Report abuse