Home > Discussion Groups > Axis

Message posting guidelines:

  • Full real names must be used at all times.

  • A valid e-mail address must be provided. (This is not optional)

  • Images must be posted at low resolution (72 dpi) and no larger than 760 pixels wide, and copyright/trade mark owners must be credited whenever reasonably possible.

  • Registration is compulsory if you wish to post messages on the Discussion Groups. For further information, please see the following message: http://www.network54.com/Forum/message?forumid=47207&messageid=1113822984

Please read our Community guidelines before posting.

By contributing to this discussion group, you indicate your agreement to the Terms and Conditions of Use.

Posts that violate the guidelines or Terms and conditions of Use of the Missing-lynx.com discussion groups will be erased, and repeated violation of this policy may result in termination of the violator's account.


Advertisement

 Return to Index  

The drawing is not quite right

June 7 2017 at 1:37 PM
Kurt Laughlin  (Login Kurt-Laughlin)
Missing-Lynx members
from IP address 65.222.251.100


Response to Calling all tow cable experts...

Between the sleeve and the eye the rope folds back onto itself so it would be an 8 shape in cross-section there. There are some ropes that had spliced eyes but these usually didn't have sleeves.

Also, wire rope in these sorts of applications is normally hexagonal in cross-section shape rather than circular. At least in American practice, rope diameter is measured across the corners, not across the flats, as would be the case if it were solid bar rather than rope. You should verify that your measurements correspond with the prevailing practice.

KL

 
 Respond to this message   


Terms and Conditions of Use
Report abuse