Home > Discussion Groups > Axis

Message posting guidelines:

  • Full real names must be used at all times.

  • A valid e-mail address must be provided. (This is not optional)

  • Images must be posted at low resolution (72 dpi) and no larger than 760 pixels wide, and copyright/trade mark owners must be credited whenever reasonably possible.

  • Registration is compulsory if you wish to post messages on the Discussion Groups. For further information, please see the following message: http://www.network54.com/Forum/message?forumid=47207&messageid=1113822984

Please read our Community guidelines before posting.

By contributing to this discussion group, you indicate your agreement to the Terms and Conditions of Use.

Posts that violate the guidelines or Terms and conditions of Use of the Missing-lynx.com discussion groups will be erased, and repeated violation of this policy may result in termination of the violator's account.


Advertisement

 Return to Index  

Think I figured it out, though.........

June 8 2017 at 9:21 PM
Ron Hetherington  (Login veezerboy)
Missing-Lynx members
from IP address 104.35.220.3


Response to Question on Assembly of RB Tiger I Barrel Early......

Not sure where the solid ring goes, so just left it off.

center section is long side out and both nut rings go on this side.

 
 Respond to this message   
Responses

  1. Maybe this helps? - Arild Moland on Jun 9, 2017, 2:17 AM
    1. Thanks!! David, question for you then....... - Ron Hetherington on Jun 9, 2017, 7:09 PM
      1. Aber's Part 3 ? - David Byrden on Jun 9, 2017, 7:31 PM
     


Terms and Conditions of Use
Report abuse