Home > Discussion Groups > Axis

Message posting guidelines:

  • Full real names must be used at all times.

  • A valid e-mail address must be provided. (This is not optional)

  • Images must be posted at low resolution (72 dpi) and no larger than 760 pixels wide, and copyright/trade mark owners must be credited whenever reasonably possible.

  • Registration is compulsory if you wish to post messages on the Discussion Groups. For further information, please see the following message: http://www.network54.com/Forum/message?forumid=47207&messageid=1113822984

Please read our Community guidelines before posting.

By contributing to this discussion group, you indicate your agreement to the Terms and Conditions of Use.

Posts that violate the guidelines or Terms and conditions of Use of the Missing-lynx.com discussion groups will be erased, and repeated violation of this policy may result in termination of the violator's account.



Photo by Manus

June 11 2017 at 11:53 AM
Andrew deeley   (Login deeley)
Missing-Lynx members
from IP address

Response to Re: Mudguard hinge area


Slightly off topic, hope it's ok.

Can some please explain to me what's going on in the photo posted by Manus ?

I see

Red Prime base with a blue grey colour painted over it This blue grey then appears to be over painted with Dunkelgelb. Except in small segments the below weid beads. Finally there's a horizontal demarcation line slightly below the three weld beads where the Dunkelgelb has been applied directly over the Red Primer and there seems to have been no application of the blue grey colour in this area. Apart from a few spot ans splashes.

Am I wrong in my interpretation and what is this blue grey colour ?


 Respond to this message   

  1. Re: Photo by Manus - M. Gallagher on Jun 12, 2017, 12:38 AM
    1. Thank you - Andrew deeley on Jun 12, 2017, 4:01 AM
    2. Thanks Manus... - Yann Jouault on Jun 12, 2017, 12:22 PM
      1. Wheatcroft tiger glacis - Don Campbell on Jun 14, 2017, 12:01 AM
        1. Very helpful! - Jens Mühlig on Jun 15, 2017, 2:04 PM

Terms and Conditions of Use
Report abuse