Home > Discussion Groups > Axis

Message posting guidelines:

  • Full real names must be used at all times.

  • A valid e-mail address must be provided. (This is not optional)

  • Images must be posted at low resolution (72 dpi) and no larger than 760 pixels wide, and copyright/trade mark owners must be credited whenever reasonably possible.

  • Registration is compulsory if you wish to post messages on the Discussion Groups. For further information, please see the following message: http://www.network54.com/Forum/message?forumid=47207&messageid=1113822984

Please read our Community guidelines before posting.

By contributing to this discussion group, you indicate your agreement to the Terms and Conditions of Use.

Posts that violate the guidelines or Terms and conditions of Use of the Missing-lynx.com discussion groups will be erased, and repeated violation of this policy may result in termination of the violator's account.



Interesting defect I encountered during my Tiger I builds.....

June 12 2017 at 11:43 PM
Ron Hetherington  (Login veezerboy)
Missing-Lynx members
from IP address

The commanders cupola hatch has a hole in it!! There are 3 welded on disks on the hatch, the one right under the outer handle is drilled thru!!! Noticed it while working on the 131 kit, then looked at the Tunisian kit, same thing. Another Tunisian kit was ok. Had to go the spare sprue box and use that one. Didn't notice any change to the "F" sprue, so not sure why Dragon drilled thru the part???

 Respond to this message   

  1. Dragon are looking into it. n/t - David Byrden on Jun 13, 2017, 8:34 AM

Terms and Conditions of Use
Report abuse