Home > Discussion Groups > Allied

Message posting guidelines:

Full real names must be used at all times.

A valid e-mail address must be provided. (This is not optional)
Images must be posted at low resolution (72 dpi) and no larger than 760 pixels wide, and copyright/trade mark owners must be credited whenever reasonably possible.

From 20 April, registration is compulsory if you wish to post messages on the Discussion Groups. For further information, please see the following message: http://www.network54.com/Forum/message?forumid=47208&messageid=1113823018

Please read our Community guidelines before posting.
By contributing to this discussion group, you indicate your agreement to the Terms and Conditions of Use.
Posts that violate the guidelines or Terms and conditions of Use of the Missing-lynx.com discussion groups will be erased, and repeated violation of this policy may result in termination of the violator's account.


 Return to Index  

Sherman Dished Idlers?????

May 20 2012 at 10:17 PM
  (Login Warfrost)
Missing-Lynx members
from IP address

Has anyone come across any manufacturer yet? I need one for my Monster. Am I going to make it unreal or has sonmeone made them yet?

This message has been edited by Warfrost from IP address on May 21, 2012 9:58 AM

 Respond to this message   

  1. Re: Sherman Dished Idlers????? - Gary Owsley on May 21, 2:46 AM
    1. Exactly! - Mark Aldrich on May 21, 7:59 AM
      1. They're in the CyberHobby M4A2 Beute Sherman kit... - Jeremy Moore on May 21, 8:24 AM
        1. Thanks - Mark Aldrich on May 21, 9:59 AM
      2. Re: Exactly! - Gary Owsley on May 22, 1:17 AM
        1. Thanks again!!! - Mark Aldrich on May 22, 12:25 PM
  2. formations? - Aaron Smischney on May 21, 4:29 PM
    1. Nope - Mark Aldrich on May 21, 5:23 PM
      1. Ok - Aaron Smischney on May 21, 10:37 PM
        1. I think so! - Mark Aldrich on May 22, 12:43 AM
  3. how about this? - Aaron Smischney on May 23, 8:17 PM
    1. Why not just put a kit part in a lathe . . . - Kurt Laughlin on May 23, 8:43 PM
      1. Because... - Aaron Smischney on May 23, 9:38 PM

Terms and Conditions of Use
Report abuse