Home > Discussion Groups > Allied

Message posting guidelines:

Full real names must be used at all times.

A valid e-mail address must be provided. (This is not optional)
Images must be posted at low resolution (72 dpi) and no larger than 760 pixels wide, and copyright/trade mark owners must be credited whenever reasonably possible.

From 20 April, registration is compulsory if you wish to post messages on the Discussion Groups. For further information, please see the following message: http://www.network54.com/Forum/message?forumid=47208&messageid=1113823018

Please read our Community guidelines before posting.
By contributing to this discussion group, you indicate your agreement to the Terms and Conditions of Use.
Posts that violate the guidelines or Terms and conditions of Use of the Missing-lynx.com discussion groups will be erased, and repeated violation of this policy may result in termination of the violator's account.


 Return to Index  

Use of firing supports on the 57mm AT Gun?

June 22 2012 at 7:59 PM
Mike Powell  (Login easy1prod)
Missing-Lynx members
from IP address

Just started putting together the new Orange Hobby 57mm AT Gun. Instructions show a travel mode and a firing mode. The firing mode shows the firing supports (a skid like support on the axle) lowered to the ground raising the wheel off the ground. The Field Manual calls for the gun to be set on the supports whenever fired.

However, in the few photos I have of the 57mm in action, I can't see these supports being used. Anyone out there have a photo of their use? From what I've read, the 57mm kicked like a mule when fired. (so much so that the FM suggests two of the assistants lay across the trails, if the spades aren't set fully.) It would seem to me that these firing supports would do little to prevent backward motion during recoil and actually slow down returning the gun to its original position for a second shot.


 Respond to this message   

Terms and Conditions of Use
Report abuse