Home > Discussion Groups > Allied

Message posting guidelines:

Full real names must be used at all times.

A valid e-mail address must be provided. (This is not optional)
Images must be posted at low resolution (72 dpi) and no larger than 760 pixels wide, and copyright/trade mark owners must be credited whenever reasonably possible.

From 20 April, registration is compulsory if you wish to post messages on the Discussion Groups. For further information, please see the following message: http://www.network54.com/Forum/message?forumid=47208&messageid=1113823018

Please read our Community guidelines before posting.
By contributing to this discussion group, you indicate your agreement to the Terms and Conditions of Use.
Posts that violate the guidelines or Terms and conditions of Use of the Missing-lynx.com discussion groups will be erased, and repeated violation of this policy may result in termination of the violator's account.


 Return to Index  

Re: ISU-122 conversion

August 2 2012 at 6:09 AM
Shane Ahyong  (Login Stomy)
Missing-Lynx members
from IP address

Response to ISU-122 conversion

Presumably you mean if converting to the ISU-122s with the rounded mantlet etc. The mantlet of the ISU-152 and 122 (with A-19) appear to be the same (although there does seem to be a few subtle variations among the 152's). For the A-19 version ISU-122, the best aftermarket barrel seems to be Model Point piece. Unfortunately, it can't be directly used with the Tamiya ISU-152, but needs an spacer at the base of about 4 mm - easily done. It will then scale out well to plans in Russian books. The bigger problem with the Model Point barrel is that it has step about 10 mm in the from the base which would need to be faired over somehow. Otherwise, it would look just right.


 Respond to this message   

Terms and Conditions of Use
Report abuse