Home > Discussion Groups > Modern

Message posting guidelines:
1.

Full real names must be used at all times.

2.
A valid e-mail address must be provided. (This is not optional)
3.
Images must be posted at low resolution (72 dpi) and no larger than 760 pixels wide, and copyright/trade mark owners must be credited whenever reasonably possible
Please read our Community guidelines before posting.
By contributing to this discussion group, you indicate your agreement to the Terms and Conditions of Use.
Posts that violate the guidelines or Terms and conditions of Use of the Missing-lynx.com discussion groups will be erased, and repeated violation of this policy may result in termination of the violator's account.



 Return to Index  

Hull side - not the torsion bar mounts

August 7 2017 at 7:37 AM
John Tapsell  (Login John_Tapsell)
Missing-Lynx members
from IP address 78.40.233.10


Response to NT

Hi Mike,

Thanks for responding - I'm referring to the big plate that sits on the hull above the torsion bar housings.

On the right side (your first photo) it extends approximately three quarters along the hull (starts immediately behind the idler wheel mounting point and finishes immediately behind the rear return roller mount). On the left side it only extends about halfway (finishes just behind the third torsion bar housing).

Regards,
John


 
 Respond to this message   


Terms and Conditions of Use
Report abuse